Polar Scope and Laser
Please note: The laser is quite powerful, so it’s recommended to wear protective glasses when calibrating it. When adjusting the screws, please do it gently — do not use too much force. If the laser pointer is damaged due to...
Continue reading
The laser cannot be secured to the polar scope mount with the nylon screw included, as the original screw (M4 × 8) is too short. To attach a laser, you’ll need to replace it with a longer nylon screw...
Continue reading
Please turn the DEC plate inside the GTi a little bit to open up the polar scope port inside, then the laser beam can come through
Please feel free to contact us if there is still any issues.
Continue reading
Please check if you remove the insulating paper inside the laser and the battery power. If everything is in order, the weak laser beam is likely caused by misalignment between the laser and the NOMAD laser hole. Please use the wrench coming...
Continue reading
Focusing the polar scope is separated in 2 steps: Focusing the reticle - Simply look through the finderscope and rotate the eyepiece ring clockwise or counterclockwise until the reticle is sharp. Note that it's important to focus your eye on...
Continue reading